Temporary Error.

Please try reloading the page.

09/28/2013
By: michael.rubio.562
Riverside Auto Stereo
Watsonville has a few small auto stereo places where you can go and have your system of deck put in. I tried Riverside Auto Stereo because it was close to my house and my brother had a deck put into his car put in by them. Small shop with fair pricing. I only needed my amp and subwoofers hooked up in the trunk. Andres charged me only 60.00 to install the equipment. I decided to buy the wiring set 40.00 to make it a nice and clean install. No pressure to buy anything else. Work was done in about an hour or less. My car was thumping like crazy. It seems they work on cars that mainly blast hip hop and so he set my car up to thump LOUD. I turned down the gain on the amp and everything was all good after that. Also it is cash only.
Tips & Advices
A capacitor is a two-terminal electrical component that is able to store energy, thus they are often found in power supplies. They can be especially important in a stereo system because they can exhibit frequency dependent behavior. What this means is they can be tailored to be used as noise filters to reduce the appearance of a frequency, or they can be used to enhance it. This is particularly effective in differentiating and isolating the ranges in a subwoofer and a tweeter, and in filtering out the potential noise or feedback from the power source.
Most aftermarket speakers are compatible with your factory stereo system. There can be exceptions, for instance, if you have speakers that need extra amplification to drive them to maximum performance, such as large subwoofers, your factory deck may not have the power to drive them adequately. They will play, but not to their potential. Basic speakers should be able to plug right into most standard decks. Factory stereo systems have evolved dramatically over the years and can even meet or exceed aftermarket products.
To install a basic car stereo you will need a minimum of tools. First you may need a puller to remove the existing deck (if there is one). Usually it’s just a thin bar that hooks onto the unit to pull it out. Once the unit space is established, you will need crimpers and wire cutters to strip, connect, and crimp the wiring units (to the speakers and to your power source). It’s a good idea to use connectors for the wiring contacts. It is a simple and basic process. In some cases, you might need some additional basic tools like screwdrivers if you are mounting anything or customizing the dash.
With a basic knowledge and minimum of tools, it is not theoretically difficult to install a car stereo. It is even easier is you are replacing the old deck because the wiring for the speakers and the power source are already in place. Most existing units can be pulled easily from the dash and replaced quickly. This of course depends on the sophistication of the system and the skill of the installer. If no modifications are necessary, it is not an overly difficult or complicated process. There are many sources of information and instructional videos available on the internet to guide you.
A subwoofer is a speaker that is designed to produce sounds on the low end of the audio scale. Subwoofers are usually paired with tweeters, speakers that produce sounds on the higher end of the audio scale, to create a balanced sound.

Just a moment...