Overhead Door Company Of Little Rock in North Little Rock, AR with Reviews - YP.com
Book appointments, post photos, and write reviews.Open in YP App
By: Charles D.
Overhead Door Company of Little Rock
If you are getting this company to work for you; go to the bank and get a loan. They charge a lot per hour for the work preformed. I had a three hour job that cost 625.95$, labor and trip was 565.00$ parts 20.00$ and tax was 40.95$. The round trip is two hours of windshield time for them. That is 94.00$ per hour!!!! NOT TO MENTION THAT THEY TOOK OFF FROM MY JOB IN THE MIDDLE OF THE JOB TO GO DO ANOTHER DIFFERENT JOB...... TWO DAYS LATER I buy a new operator system from Jack, for the tune of 1500.00$ and HE still charged me the full trip fee from the prior trip. He should have discounted it some or at least half. BUT 2125.95$ later the door does work. POINT is Overhead Door Co. of Little Rock (Jack) you are expensive in your labor and trip fees. NOT recommended, but only as a last resort only if your pocket book can stand their charges.
Tips & Advices
Basic screen-door fixes can be pretty cheap, and most can be DIY fixes. Replacing a door closer can cost less than $15. Door hinges and latches are usually less than $10, unless you are getting really fancy. You’ll probably only need a basic screwdriver and possibly some screws or shims. Replacing the mesh can be more difficult, so weigh the value of mesh replacement vs. full door replacement when considering the actual screen replacement.
Screen door installation, for a standard swinging door (not a sliding screen), is relatively inexpensive. Depending on your area, expect to pay $50-$100 for installation costs. The doors themselves are usually inexpensive and can be as low as $40 (beware of the quality). If you are handy around the house, installing a screen door can be a great DIY opportunity.
A screen-door closer, or a pneumatic cylinder, is a device connecting the screen door to the door jamb. It is usually located at the top of the door and is designed to close the screen door automatically after opening. They can be easily adjusted to quicken or slow the door’s closing speed.
To stop a screen door from slamming shut, adjust the door closer, usually located at the top of the door. There is a cylinder inside the door closer that controls how fast or slow the door closes, and it is usually adjustable with a simple screw driver. If adjusting makes no difference, the door closer might be faulty and need replacing – a low-cost DIY project that requires minimal time and tools.
The most common cause of a sagging screen door is loose or worn hinge screws that attach the screen to the door frame. If they are loose, you can tighten them yourself. A loose latch between the door and the door frame is also a common cause of sagging. Again, check the screws and tighten them up if they’re loose.

Just a moment...