Best 7 Car Radio Installation in Kingston, NY with Reviews - YP.com
Book appointments, post photos, and write reviews.Open in YP App

Temporary Error.

Please try reloading the page.

12/14/2016
By: Mike B.
Hammer Electronics
Went here with a commuter car to have a remote starter installed and then returned for sattelite radio installation.Inside of 2 years, both key fobs for remote starter failed....I was told that they had never seen these key fobs fail, yet I had 2 that both failed.Of course a simple repair.....replace the key fobs at $100 each.These guys sell poor quality equipment at a high price and do not stand behind it at all.My business will not be conducted there again.....very disappointing as I am someone who believes in supporting local small businesses.
user avatar
03/11/2016
By: Michelle D.
Hammer Electronics
Ya they gave me a ride...installed wrong speakers that sounded like crap and told me I had to much bass in my cds..shady is all I can say..then took 2 days with my car to fix..nice while taking your money then very rude and act like you don't know what a stereo should sound like when it sounds like crap.I think they were mad they didn't get over on putting the wrong bad speakers they put in my car..get receipts boxes and paperwork for everything..now I am nervous on the installation...
Tips & Advices
A capacitor is a two-terminal electrical component that is able to store energy, thus they are often found in power supplies. They can be especially important in a stereo system because they can exhibit frequency dependent behavior. What this means is they can be tailored to be used as noise filters to reduce the appearance of a frequency, or they can be used to enhance it. This is particularly effective in differentiating and isolating the ranges in a subwoofer and a tweeter, and in filtering out the potential noise or feedback from the power source.
Most aftermarket speakers are compatible with your factory stereo system. There can be exceptions, for instance, if you have speakers that need extra amplification to drive them to maximum performance, such as large subwoofers, your factory deck may not have the power to drive them adequately. They will play, but not to their potential. Basic speakers should be able to plug right into most standard decks. Factory stereo systems have evolved dramatically over the years and can even meet or exceed aftermarket products.
To install a basic car stereo you will need a minimum of tools. First you may need a puller to remove the existing deck (if there is one). Usually it’s just a thin bar that hooks onto the unit to pull it out. Once the unit space is established, you will need crimpers and wire cutters to strip, connect, and crimp the wiring units (to the speakers and to your power source). It’s a good idea to use connectors for the wiring contacts. It is a simple and basic process. In some cases, you might need some additional basic tools like screwdrivers if you are mounting anything or customizing the dash.
With a basic knowledge and minimum of tools, it is not theoretically difficult to install a car stereo. It is even easier is you are replacing the old deck because the wiring for the speakers and the power source are already in place. Most existing units can be pulled easily from the dash and replaced quickly. This of course depends on the sophistication of the system and the skill of the installer. If no modifications are necessary, it is not an overly difficult or complicated process. There are many sources of information and instructional videos available on the internet to guide you.
A subwoofer is a speaker that is designed to produce sounds on the low end of the audio scale. Subwoofers are usually paired with tweeters, speakers that produce sounds on the higher end of the audio scale, to create a balanced sound.

Just a moment...