Juice It Up Locations & Hours Near Denver, CO - YP.com
Book appointments, post photos, and write reviews.Open in YP App
  • 1.Livin It Up Juice Inc

    10721 W 101st Pl

    Broomfield,CO

    12.40 mi

  • 2.Seven Up-Rc Bottling Co

    2840 S Zuni St

    Englewood,CO

    5.39 mi

  • 3.Juice It Up

    8401 Park Meadows Center Dr

    Lone Tree,CO

    13.71 mi$

Temporary Error.

Please try reloading the page.

user avatar
10/20/2015
By: Mary K.
Jamba Juice
Asked for fresh carrot and orange juice. I said please it has to be juiced now. They said oksy then gave me stuff out if the refrigerator. Talked with manager who said they would re do it but the machines were down for ckeaning. No offer of refund. No attempt to make it right. Manager polite was ineffective. Male employee surly. I'm at a Jamba juice 5 times a week. Worst one is at Denver Airport C terminal.
07/16/2014
By: Patrick J.
Liquiserve
I dont normally write up negative reviews, unless it's truly deserving and really hope the owners see this and make corrective practices. I bought a Rancilio and wanted them to service it. I run a small non-profit and dropping off the machine to them was to take 1-2 weeks, but for a fee they could come out and work on it. There person (I know his name, just leaving it out) showed up, turned it on, and everything was working swell.. unless the bar pressure didnt stop climbing and the safety valve blew off. Happened twice. I was told it was a bad temp sensor or logic board. Cheapest option was the Temp Sensor at $80. So I had them order it. Suppose to come 2-3 day, and after a week I called, 2 weeks I called, and the 3rd week I left a message to make sure they canceled my order and made sure they didnt charge me for the part, told them my complaint, and still no call back... The sad part is, ME and inexperienced person, with no knowledge googled and found the fix in 10 mins. All the service person had to do was adjust the potentiometer to stop at the desired bar pressure... That's it... instead, the safety valve blew, trash.. and it cost me $150 to have them out, and they billed me for a gasket which wasn't the right one, because they didnt have one on the truck... when then knew they were coming out for... $150 and i got a gasket which isn't the raight one. Again, I hope this company fixes the issue, cause Im out $150 for installing a wrong gasket and to be told they would need to order additional parts when they should have just adjusted the only screw on the logic board. I feel ripped off and scammed.

Just a moment...